Bb-electronics 856-18700 - Manual Manual de usuario

IE-iMcV-MediaLinX TX/SFP iMcV-MediaLinX TX/FX Operation Manual

7 FA is used when connecting to a device that does not support FEF. If an FEF signal is sent to a device that does not support FEF, the device acts a

8 Additional IE-iMcV-MediaLinX TX/SFP Features Selective Advertising Selective Advertising, when used in combination with Auto Negotiation, advertises

9 AutoCross Feature for Twisted Pair Connection All twisted pair ports on the IE-iMcV-MediaLinX TX/SFP include AutoCross, a feature that automatically

10 Installation Troubleshooting • During installation, first test the fiber and twisted pair connections with all troubleshooting features disabled, t

11 Fiber Optic Cleaning Guidelines Fiber Optic transmitters and receivers are extremely susceptible to contamination by particles of dirt or dust, whi

12 Certifications CE: The products described herein comply with the Council Directive on Electromagnetic Compatibility (2004/108/EC). For further

19772 Pauling y Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 y FAX: (949) 465-3020 www.imcnetworks.com © 2010 IMCNetworks. All

ii FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B computing device, pursu

iii Table of Contents FCC Radio Frequency Interference Statement ...ii Warranty...

1 About the IE-iMcV-MediaLinX TX/SFP NOTE Unless noted otherwise, all references to the IE-iMcV-MediaLinX TX/SFP in this manual are also applicable t

2 Managed Modules To manage one or more IE-iMcV-MediaLinX TX/SFP Modules, an SNMP agent must be present in the chassis: The iMediaChassis series requ

3 The SNMP Write Lock switch does not impact any iMcV-Module or IE-iMcV-Module with Configuration Control. Removing and installing a new SNMP Managem

4 FX LinkLoss, TX LinkLoss, Link Fault Pass-Through, FiberAlert and Far End Fault IE-iMcV-MediaLinX TX/SFP modules include the troubleshooting feat

5 FX LinkLoss (FXLL) FX LinkLoss is a troubleshooting feature. When a fault occurs on the fiber segment of a conversation, FX LinkLoss detects the fa

6 FiberAlert (FA) By default FA is turned off. When enabled, if a fault occurs on the fiber line, affecting data in one direction, FA stops sending a